Tape one edge of the template to the installation surface and unroll it. Level the template and tape the other edge of the installation surface.

Mark holes with center punch, then drill 1/4" holes 3" deep where indicated on your template. Remove the template and clean out all drill holes using any of the following methods: a quick puff of air, using the vents on your drill, compresses air or a turkey baster.

Insert the studs into the stud holes on the back of each letter. Place letters in holes on wall before applying silicone to verify position. Adjust as necessary. Now fill the drill holes in the wall of the first letter with silicone.

Push the tube of silicone over each stud on the first letter in order to evenly coat it with adhesive.

Push the letter into the drill holes using a shim or spacer to assure proper stand off of the letter from the wall. Repeat steps 2 through 4 for the rest of the letters.

Clean the installation surface firs. Position the spacing tape on the wall and secure one end with masking tape. Unroll, level and tape the other end. Spacing tapes show the general position of each letter.

Apply silicone to all the pads on the letter first. Position the letter on the wall where indicated with the spacing tape. Tape the letter to the wall with several strips of masking tape.

Adjust as needed, push letter against wall to ensure good adhesive bond. Continue with the remainder of the letters, and allow the silicone to cure before removing the masking tape. Temperature and humidity will influence silicone cure times. On some conditions letters should cure overnight.